|
Re: Rear hub nut tightness questions.
I will check it out!
thanks
Dan
Midwest Amphicar wrote:
Quote:
> Dr. Noose, what probably happened to your car in the past is the hub
> slipped. Then by spinning it enlarged by a few thousands. The taper
> does not allow it to go further so it never gets tight enough. There
> are other solutions but cheapest is to use a bit of aluminum from a
> can, wrap axle area where hub contacts. The aluminum will fit via the
> force of installing hub. Realize there are different thicknesses
> between cans say Coors light compared to 7up. Rear hubs are around
> $400? Later Dave the Wave
>
>
|
------------------------------------------------------------------------
GORDON IMPORTS INC.. The world's largest source of Amphicar parts and accessories. Visit our new website today.
__________________
Dan
AKA DrNoose
1964 Amphicar
AKA Das Boot
|